<div dir="ltr"><div class="gmail_quote"><div dir="ltr" class="gmail_attr">New FreedomBox was working great without the backup battery attached. Decided I wanted battery backup after all so I did the following:<br></div><div dir="ltr"><div><br></div><div>1) shutdown with ssh and "sudo shutdown -h now"</div><div>2) removed power and ethernet cables, attached battery to A20 board</div><div>3) reattached ethernet and then power </div><div>4) no typical ethernet lights showing but small red board LED showed board had power</div><div>5) no response to ssh</div><div>6) tried PWR button hold for 5 seconds - no response (did this twice)</div><div>7) tried RESET button - no response</div><div>8) tried RECOVERY button - no response</div><div><br></div><div>The only way to get my FreedomBox back up and working was to remove the backup battery from the board pins.</div><div><br></div><div>There seems to be either some hardware fault when the battery is attached or my sequence of attempting a restart using the small front panel buttons is incorrect. </div><div><br></div><div>Has anyone else noticed this problem and/or have a solution?</div><div><br></div><div>Thanks in advance for any assistance.....Larry</div><div><br><div><br></div></div></div>
</div></div>