<div dir="ltr">I'm trying to get SNMPv3 management working for an APC AP9617 card. It is newly refurbed, running sumx v3.7.2 and aos v3.7.3.<div><br></div><div>In the SNMPv3 user profiles section I have (I don't care about the password leaking, it's temporary):</div><div><br></div><div>  User Name: nut</div><div>  Authentication Passphrase: NutScan@Password43LongerWord</div><div>  Privacy Passphrase: NutScan@Password43LongerWord</div><div>  Authentication protocol: MD5 (only option other than none)</div><div>  Privacy Protocol: DES (only option other than none)</div><div><br></div><div>In access control I've enabled user nut.</div><div><br></div><div>However, when I try to use nut-scanner on it:</div><div>$ nut-scanner -S -s apcups --secLevel authPriv --secName nut --authProtocol MD5 --authPassword NutScan@Password43LongerWord --privProtocol DES --privPassword NutScan@Password43LongerWord<br>Scanning SNMP bus.<br>Error: unknown authtypeError generating Ku from authentication pass phrase<br></div><div><br></div><div>snmpwalk gives a different error:</div><div>$ snmpwalk -v 3 -u nut apcups -x DES -X NutScan@Password43LongerWord -a MD5 -A NutScan@Password43LongerWord<br>snmpwalk: Decryption error<br></div><div><br></div><div>I've tried it with all lowercase, mixed case, mixed case + numbers, and the one you see here. I've also used an 18 character password. All get exactly the same result.</div><div><br></div><div>I've tried setting the privacy protocol to none and leaving off the -x & -X flags, still get the same error messages.</div><div><br></div><div>I see a note in APC's documentation that it may take some time for the card to be ready to talk SNMPv3. I've waited as long as 15 minutes with no change in behavior.</div><div><br></div><div>snmpwalk and nut-scanner are both happy SNMPv1 -c public.</div><div><br></div><div>Can anyone tell me, please, what trivially obvious thing am I missing?</div><div><br></div><div>thanks,</div><div>nomad</div></div>