<div dir="ltr">Hi,<div><br></div><div>I've recently bought the UPS in subject to support a small load (around 60-80W). I've installed nut and did the basic configuration and confirmed basic communication. At that stage I did not configure upsmon, but simply was monitoring the values.</div><div>I carried out a test to see how long the setup would last - according to the values reported via upsc - it should have been around 45mins. After reaching 45mins the ups reported low battery, in fact the battery.charge got down to 0 (so did the battery.runtime), but the power was still being supplied. Ultimately after about 2h 10min I ran out of time to test and turned the power back on. </div><div><br></div><div>Clearly either the values reported by the UPS or the interpretation inside the driver is not correct. How can I correct this? </div><div><br></div><div>These are the values reported by the ups (there was a short power outage before):</div><div>battery.charge: 23<br>battery.runtime: 696<br>battery.type: PbAc<br>device.mfr: EATON<br>device.model: 5E 2000i<br>device.type: ups<br><a href="http://driver.name">driver.name</a>: usbhid-ups<br>driver.parameter.pollfreq: 30<br>driver.parameter.pollinterval: 2<br>driver.parameter.port: auto<br>driver.parameter.synchronous: no<br>driver.parameter.vendorid: 0463<br>driver.version: 2.7.4<br>driver.version.data: MGE HID 1.39<br>driver.version.internal: 0.41<br>input.voltage: 234.0<br>outlet.1.status: on<br>outlet.desc: Main Outlet<br><a href="http://outlet.id">outlet.id</a>: 1<br>outlet.switchable: no<br>output.frequency: 49.9<br>output.frequency.nominal: 50<br>output.voltage: 237.0<br>output.voltage.nominal: 230<br>ups.beeper.status: enabled<br>ups.delay.shutdown: 20<br>ups.firmware: 03.08.0020<br>ups.load: 3<br>ups.mfr: EATON<br>ups.model: 5E 2000i<br>ups.power.nominal: 2000<br>ups.productid: ffff<br>ups.start.battery: yes<br>ups.status: OL<br>ups.timer.shutdown: -1<br>ups.vendorid: 0463<br></div><div><br></div><div>kind regards</div><div>Pshem</div><div><br></div></div>