<br><br>Le dimanche 7 avril 2019, <<a href="mailto:gcab_dzan@libero.it">gcab_dzan@libero.it</a>> a écrit :<br>> a) no, winbind is not installed (and is not installed under Stretch 9.8, where the samba connection is working perfectly).<br><br>Can you try wih winbind installed (and all samba services restarted)?<br><br>> b) for the moment, I just set up a point-to-point ethernet cable connection with an old pc running winxp, within the same workgroup, and I just use the file \etc\hosts to map the addresses (pinging is ok both ways).<br>> c) don't get what you mean by command; I use smbtree to check that the shares on both pc's are visible, after that (normally) I can browse through a file manager, and in fact I can do that through Krusader running with root privileges.<br>><br>><br>><br>>> Il 6 aprile 2019 alle 21.58 Mathieu Parent <<a href="mailto:math.parent@gmail.com">math.parent@gmail.com</a>> ha scritto:<br>>><br>>><br>>> Le sam. 6 avr. 2019 à 16:00, <<a href="mailto:gcab_dzan@libero.it">gcab_dzan@libero.it</a>> a écrit :<br>>> ><br>>> > Hi, Mathieu, thanks for your reply.<br>>> ><br>>> > I tried either with the new smb.conf (att. smb.conf.up1)  suggested during installing samba, and with the version taken from previous releases and which is working flawlessly in Stretch (att. smb.conf.ucf-old). Does not change the problem.<br>>><br>>> Is Winbind installed? Are you using pam_winbind and nss_winbind? What<br>>> is your complete command?<br>>><br>>> Regards<br>>><br>>> --<br>>> Mathieu Parent<br>><br>><br><br>-- <br>Mathieu<br>