<div dir="auto">Usually, those scan to pc functionality require either a (anonymous) SMB/ FTP folder or prop. driver on the target PC.<div dir="auto">If your scanner is connected to the network, try to reach the web interface of the browser by it's IP Address to configure your scan buttons. </div><div dir="auto"><br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">Perry Hutchison via sane-devel <<a href="mailto:sane-devel@alioth-lists.debian.net">sane-devel@alioth-lists.debian.net</a>> schrieb am Sa., 4. Dez. 2021, 03:58:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">A data point:<br>
<br>
The Canon MF4880dw -- a multifunction device with network and USB<br>
interfaces -- has two buttons, labelled Scan->PC1 and Scan->PC2,<br>
which seem as if they could be of interest to sane.  When I attempt<br>
to configure one of those buttons using the front panel, selecting<br>
"Network connection" (rather than "Off" or "USB connection") displays<br>
"Connect computer" for a couple of seconds before redisplaying the<br>
Off/USB/Network selection screen.  (Interestingly, selecting "USB<br>
connection" does not require anything to be connected to the<br>
scanner's USB interface.)<br>
<br>
I haven't tried to figure out how the scanner determines that a<br>
computer is connected.  There are in fact several computers on the<br>
network, but none running any Canon software, which leads me to<br>
suspect that -- before configuring the Scan->PC# buttons -- the<br>
computer(s) to be used as destination(s) would need to be set up.<br>
(I had hoped that the front panel configuration menus would allow<br>
an IP address and port number to be set for each of the buttons.)<br>
<br>
</blockquote></div>