[3dprinter-general] Patch used when uploading libarcus

[Petter Reinholdtsen]

Hi.  I just uploaded libarcus as part of the introduction of cura in
Debian.  This is the changelog patch I used:

diff --git a/debian/changelog b/debian/changelog
index 1216a7c..6805191 100644
--- a/debian/changelog
+++ b/debian/changelog
@@ -1,5 +1,5 @@
-libarcus (2.5.0-1) UNRELEASED; urgency=medium
+libarcus (2.5.0-1) unstable; urgency=medium
 
   * Initial Debian release. Closes: #706656
 
- -- Gregor Riepl <onitake at gmail.com>  Wed, 26 Apr 2017 08:17:37 +0200
+ -- Gregor Riepl <onitake at gmail.com>  Sun, 01 Oct 2017 04:13:23 +0000

Note, I am not quite sure it is correct to close #706656 (request for
cura) with this upload, but left it as it is.

-- 
Happy hacking
Petter Reinholdtsen