[3dprinter-general] Bug#1040806: cura-engine: ADT failure "Trying to retrieve setting with no value given: 'adhesion_extruder_nr'"

[Gregor Riepl]

Hi Dan,

I tested the upstream CuraEngine commit and then realized that 
refreshing it results in the same patch as yours, so I pushed your 
version instead.

Now, I'm slightly confused about the version you reported this against.
According to the report, it affects 4.13, but the changes requiring the 
patch weren't even present in that version?
 From what I can see, it only affects 5.0.0.

Do we need to backport it against 4.13 in some way, or was this just a 
goof-up when you reported the bug?

In any case, this should conclude the three important issues[1] still 
present in CuraEngine 5.0.0-3. I'd appreciate if someone from the 3-D 
printing team could push 5.0.0-4 to sid, so we can get the package 
promoted to trixie soon.

Thanks a lot!

[1]
https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=1040252
https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=1037614
https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=1040806