[Babel-users] [NEWBIE]How to connect 2 Laptop using Babeld?

[sidiq]

>Run the command `iwconfig wlan0` on each laptop.  Is the sequence of

>six hex values after the string "Access Point" the same on each?

Yes

 

>Run the command `route -n` on each node.  Do you see on each laptop
>the IP address of the other laptop you're testing with?

Yes

 

So, babel has worked? But, is it as same as using normal ad-hoc mode
(without babel)?

 

Actually, I searching how to use babeld and got a guide from this:
http://disi.unitn.it/locigno/didattica/NC/10-11/Esercitazione_3_H.pdf

In that guide, after we configure babeld properly, there should appear
something like this

Adding network eth1.

Got 213:ceff:fed9:4952:8b39:c64b:2345:0 17699 1271282059 from babel-state.

Noticed ifindex change for eth1.

Noticed status change for eth1.

Netlink message: [multi] (msg -> "" 0), [multi] (msg -> "" 0),

Netlink message: [multi] (msg -> "" 0), [multi] (msg -> "found address on
interface eth1(3):

fe80::213:ceff:fed9:4952

" 1),

Netlink message: [multi] (done)

Sending hello 27317 (400) to eth1.

sending request to eth1 for any.

Noticed IPv4 change for eth1.

Sending self update to eth1.

Sending update to eth1 for any.

Etc.

But mine doesn't

How to fix it, have I configured babeld properly?

Thanks you

 

 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/babel-users/attachments/20121002/2eae4508/attachment.html>