[Debian-med-packaging] Please check maybe-failed of bali-phy
Andreas Tille
tille at debian.org
Tue Nov 3 17:57:49 GMT 2026
Hi Cheng Li,
Am Tue, Nov 03, 2026 at 11:03:16PM +0900 schrieb Cheng Li:
> I looked at the build log. This does not look like an architecture
> problem: three tests simply do not finish within their timeout on the
> riscv64 buildd and get killed.
>
> >From the test summary in the log:
>
> Ok: 785
> Fail: 0
> Timeout: 3
>
> So 3 out of 788, and no failures. All three were killed by signal 15
> (SIGTERM), and there are no architecture-specific errors and no wrong
> results anywhere in the log.
>
> The timeouts for these three tests are hardcoded in src/meson.build:
>
> 176-181 generated alignment program standalone timeout: 600 needs ~720s
> 184-185 bali-phy 5d test timeout: 300 needs ~370s
> 186-187 bali-phy 5d +A 50 timeout: 300 needs ~460s
Thank you for your analysis.
> The estimates come from comparing the 161 tests that pass on both
> riscv64 and armhf and take more than 5s: riscv64 is roughly 11x (median)
> slower than armhf. All three estimates are above the current limits, and
> close enough to them that the tests were most likely still progressing
> rather than stuck.
>
> Note that bali-phy 48 +A 3 took 487.89s against a 600s limit, only 19%
> headroom, so it is likely to be the next one to time out.
>
> As for a fix, we could raise the timeouts via dh_auto_test:
>
> dh_auto_test -- --timeout-multiplier 3
While I think this could finally work to build the package on all
architectures I wonder whether we want to stress test Debian's slow
architecture with this kind of things.
> If that sounds reasonable, I am happy to report this as a bug and
> provide a patch.
I think the optimal solution would be some flag HEAVY_TESTS (or so) in
upstream test which we can switch off from debian/rules for selected
architectures.
I'd welcome if you would create a MR upstream implementing this. As
far as I know upstream is responsible and friendly to Debian (was
even directly involved into the packaging.
Thanks again for your help
Andreas.
--
https://fam-tille.de
More information about the Debian-med-packaging
mailing list