[Nut-upsdev] Can't select phoenix as subdriver in megatec_usb

Alexander I. Gordeev lasaine at lvk.cs.msu.su
Sat Jan 5 06:45:46 UTC 2008

On Sat, 05 Jan 2008 09:22:31 +0300, Boris Kleint <kleint at ngi.de> wrote:

> Hello,
> I'm working on getting nut using a Powermust Office 650 USB USV. Using
> today's trunk megatec_usb detects its vendorid 0665 productid 5161 but
> uses the agiler driver for it which apparently does not work
> (timeout...). I think this device is using that USB-to-serial chip but a
> different protocol behind. I got the phoenix subdriver working with the
> device but I had to extend subdriver_list[] by &phoenix_subdriver in
> order to be able to specify it on the command line. Could you please fix
> this in the trunk?

Thank you!
Fixed in r1214.

> With that change the following ups.conf settings work fine with the USV:
> [powermust]
>   driver = megatec_usb
>   port = auto
>   vendorid = 0665
>   subdriver = phoenix

I think we should consider switching the corresponding entry in the list
of known devices (back) to phoenix subdriver.


More information about the Nut-upsdev mailing list