[Nut-upsuser] Sustainer S-1000C (Powercom protocol)

[Charles Lepple]

On 8/22/05, Simon Rozman <simon at rozman.si> wrote:
> If that doesn't resolve your problem, I advise you to connect to your UPS at
> /dev/ttyS0 using minicom or some other serial terminal utility (use 1200
> BPS, 8-bit, no parity, one stop bit, and no flow control at all). Send the
> \x01 character (or Ctrl+A) to the UPS.

note that the default command character in minicom is Ctrl-A, so you
would need to type "Ctrl-A Ctrl-A" (unless you have changed the
command character to Alt/Meta).

-- 
- Charles Lepple