[Nut-upsuser] Ablerex 625L USB version

[Peter Selinger]

I don't know, this doesn't look so good. Your UPS reports "0" as the
value for everything. I don't know what to do about it. -- Peter

Lau Kim Ping wrote:
> 
> 
> Peter,
> 
> Thank you very much for the patch.  After applying your patch, newhidups & upsd ran successfully.  The output of upsc is as follow:
> 
> driver.name: newhidups
> driver.parameter.port: auto
> driver.version: 2.1.0
> unmapped.ablerexups.batterysystem.batterysystemid: 0
> unmapped.ablerexups.batterysystem.presentstatus.good: 0
> unmapped.ablerexups.batterysystem.presentstatus.used: 0
> unmapped.ablerexups.batterysystem.temperature: 0
> unmapped.ablerexups.batterysystem.test: 0
> unmapped.ablerexups.batterysystem.voltage: 0
> unmapped.ablerexups.flow.configactivepower: 0
> unmapped.ablerexups.flow.configapparentpower: 0
> unmapped.ablerexups.flow.configfrequency: 0
> unmapped.ablerexups.flow.configvoltage: 0
> unmapped.ablerexups.flow.delaybeforeshutdown: 0
> unmapped.ablerexups.flow.delaybeforestartup: 0
> unmapped.ablerexups.flow.flowid: 0
> unmapped.ablerexups.flow.highvoltagetransfer: 0
> unmapped.ablerexups.flow.imanufacturer: 0
> unmapped.ablerexups.flow.iproduct: 0
> unmapped.ablerexups.flow.iserialnumber: 0
> unmapped.ablerexups.flow.lowvoltagetransfer: 0
> unmapped.ablerexups.powerconverter.output.presentstatus.ablerex1: 0
> ups.mfr: UIS Ablerex
> ups.model: Ablerex USB Interface 049e
> 
> I then turned off the main switch & then ran upsc again.  Even the UPS was on battery, the output of upsc remained the same.  I was hopping at least one of the values would dropped to a negative value.  What should I do next?  Thanks.
> 
> ****
> 
> On Sat, 23 Sep 2006 16:06:37 -0300 (ADT)
> selinger at mathstat.dal.ca (Peter Selinger) wrote:
> 
> >The patch I just sent may not work; please try this one instead. 
> >-- Peter
> >
>