[Nut-upsuser] MGE Ellipse 800 shutdown problems
mailer.tovis at freemail.hu
Thu Oct 25 16:01:07 UTC 2007
Thanks for suggetions and keep me indumb about making of Debian packages:D
I will try this package "nut_2.2.0-2_i386.deb"
One little questionm, shoud I use newmge-shut driver? - my ups is quite
old - more then 3 years, connected through serial cable.
>> PS: Arjen de Korte suspected something was wrong around my "heater" load,
>> for now I have used two 150W lamps and it cause load 52% in case
>> "ONBATTERY". When battery is charged over 95% the nut is working as
>> suspected, but after first shutdown - switch up cycle the charge is about
>> 86% and sequence does not work (usp shutdown early).
> well, this is a know behavior of the old Pulsar Ellipse. When
> restarting after a shutoff, the battery level is set to 85 %, even if
> the actual level is nearby 0, which was dumb and dangerous.
Special thanks to Arnaud for this, I suspected something like this (I have
seen what is inside my ups - one rpocessor like thing connected through 4
pins to the power module, the small plate also includes a famous 555
analog timer, such a seriouse hardware can not do much). This is again a
reason to shutdown the box(es) as quick as possible, keep it ups load
switch off as long as possible.
PS: I necer have so good support for any sw at all - include my own:)
More information about the Nut-upsuser