[Nut-upsuser] driver for my ups

[Charles Lepple]

On 9/14/07, Alexander Fradiani <a_fradiani at hotmail.com> wrote:
>
> >> The Winpower software speaks the megatec protocol, so>>"megatec_usb" is your best shot. If it doesn't work, maybe its>>maintainers can help modifying it in order to work.
> >> --> Carlos Rodrigues.
>
> i had an older version so i upgraded to nut 2.2.0-1. using the "megatec_usb" driver, this is what i get:
>       #upsdrvctl start
>       "No supported devices found. Please check your device availability with 'lsusb' and make sure you have an up-to-date version of NUT. If this does not help, try running the driver with at least 'vendorid' and 'subdriver' options specified."

Did you use the vendorid and subdriver options? Please post the full
command line.

> the only device connected via usb that i have now is the ups, i think that i'm pointing to the right port.

The traditional concept of a named "port" in NUT only applies to
serial UPSes - the software uses different mechanisms to select which
USB device to use.

-- 
- Charles Lepple