[Nut-upsuser] nutdrv_atcl_usb

[Charles Lepple]

[attachments were > 100kB; trimmed]

Begin forwarded message:

> From: "Jakub Scepka (private)" <jakub.scepka at gmail.com>
> Subject: Re: [Nut-upsuser] nutdrv_atcl_usb
> Date: March 13, 2015 at 4:30:08 PM EDT
> To: "hyouko at gmail.com" <hyouko at gmail.com>
> Cc: nut-upsuser <nut-upsuser at lists.alioth.debian.org>
> 
> 
> Hello Im back with my findings:
> 
> J: I was very complicated to find some device with higher consumption
> (except of NAS server, which is not ideal for these tests), so I ended with attached air purifier.
> 
> 
> - terminal #3:
> upsrw -s ups.delay.shutdown=30 -u admin -p pass ups
> J: nothing visible happened
> 
> upsrw -s ups.delay.start=0 -u admin -p pass ups
> J: nothing visible happened
> 
> upscmd -u admin -p pass ups shutdown.return
> # Wait ~15 seconds, then:
> J: nothing visible happened
> 
> upscmd -u admin -p pass ups shutdown.stop
> J: nothing visible happened
> 
> # Does this stop the shutdown? If so, wait ~60 seconds then:
> J: No it did not.... I'm waiting... nothing... nothing visible happened
> 
> upscmd -u admin -p pass ups shutdown.return
> J: I'm waiting a few seconds... and... yes, its gone....
> 
> # Then wait till the UPS shutdowns the load (does it happen?); wait
> one minute or so and then give back power to the UPS.
> J: Power cable reconnected, UPS remains totally death...
> 
> # In a short time frame the UPS should now start again bringing back
> power to the attached load: does this happen?
> 
> J: No, it didn't started I had to start it with button.
> It didn't started because circuit breaker did its job :D
> I'm going back to "upscmd -u admin -p pass ups shutdown.return" stepm this time with power cable attached.
> Again I had to start it with button.
> 
> # Now, just to confirm that the various 'SnRm' commands don't work,
> cut again the power to the UPS and then:
> upsrw -s ups.delay.shutdown=30 -u admin -p pass ups
> J: nothing visible happened
> 
> upsrw -s ups.delay.start=60 -u admin -p pass ups
> J: nothing visible happened
> 
> upscmd -u admin -p pass ups shutdown.return
> # Wait ~60 seconds: does the UPS shutdown the load?
> J: Waiting 1 minute or so.... nothing visible happened
> 
> Log: log-friday_13.log.tar.gz
> 
> J: Im going o try it again with power disconnected
> J:the same results, but this time, when I connected power cable, the circuit braker was fine, and UPS started fine (without touching the button).
> 
> Log: log-friday_13-second_attept.log.tar.gz


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20150316/49c4dd59/attachment-0001.html>