[Pkg-kde-extras] Bug#572304: k3b : unable to write data

[vishnu vardhan]

Excuse for replying so late.
I have reinstalled the debian from scratch.
I have burned a cd iso image before updating the os using aptitude
full-upgrade, and I was able to burn the iso image successfully.
I have upgraded the system using aptitude full-upgrade.
I have tried again today to burn iso image on a cd and it has shown error
about inability to burn the media.
Please look into the matter.

The error produced due to the burning of the iso image :

System
-----------------------
K3b Version: 1.0.5

KDE Version: 3.5.10
QT Version:  3.3.8b
Kernel:      2.6.26-2-686
Devices
-----------------------
HL-DT-ST RW/DVD GCC-4244N 1.03 (/dev/hdc, ) [CD-R, CD-RW, CD-ROM, DVD-ROM]
[DVD-ROM, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16,
RAW/R96P, RAW/R96R]

Used versions
-----------------------
cdrecord: 1.1.9

cdrecord
-----------------------
/usr/bin/wodim: Operation not permitted. Warning: Cannot raise
RLIMIT_MEMLOCK limits.
scsidev: '/dev/sr1'
devname: '/dev/sr1'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.9
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 1 = CD-ROM
Driveropts: 'burnfree'
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'MOSER   '
Identification : 'BAER DH-20A4P   '
Revision       : '9M74'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0012 (DVD-RAM)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE FORCESPEED
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 988416 = 965 KB
FIFO size      : 12582912 = 12288 KB
Speed set to 1411 KB/s
Track 01: data   547 MB
Total size:      628 MB (62:17.70) = 280328 sectors
Lout start:      629 MB (62:19/53) = 280328 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 5
  Is not unrestricted
  Is not erasable
  Disk sub type: Medium Type B, low Beta category (B-) (4)
  ATIP start of lead in:  -11834 (97:24/16)
  ATIP start of lead out: 359849 (79:59/74)
Disk type:    Short strategy type (Phthalocyanine or similar)
Manuf. index: 24
Manufacturer: SONY Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 79521
Forcespeed is OFF.
Starting to write CD/DVD at speed   8.0 in real SAO mode for single session.
Last chance to quit, starting real write in    2 seconds.
   1 seconds.
   0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Errno: 5 (Input/output error), send opc scsi sendcmd: cmd timeout after
2.037 (200) s
CDB:  54 01 00 00 00 00 00 00 00 00
cmd finished after 2.037s timeout 200s
/usr/bin/wodim: OPC failed.
Writing  time:    2.072s
Errno: 5 (Input/output error), prevent/allow medium removal scsi sendcmd:
retryable error
CDB:  1E 00 00 00 00 00
status: 0x0 (GOOD STATUS)
cmd finished after 0.000s timeout 200s
Errno: 5 (Input/output error), start/stop unit scsi sendcmd: retryable error
CDB:  1B 00 00 00 02 00
status: 0x0 (GOOD STATUS)
cmd finished after 0.000s timeout 200s
/usr/bin/wodim: Cannot eject media.
/usr/bin/wodim: fifo had 192 puts and 0 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%.

cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/sr1 speed=8 -dao driveropts=burnfree
-eject -data -tsize=280328s -

Once again please excuse for reporting the error properly.

sid.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/pkg-kde-extras/attachments/20100304/7a2d77b3/attachment-0001.htm>