vdr-plugin-xine

[Christian Schoenebeck]

Es geschah am Donnerstag, 12. Mai 2005 12:58 als Christian Schoenebeck 
schrieb:
> I installed everything, but I have a little problem; xine complains:
>
> 	There is no input plugin available to handle
> 	'vdr:/tmp/vdr-xine/stream#demux:mpeg_pes'.
> 	Maybe MRL syntax is wrong or file/stream source doesn't exist.

I was wrong; vdr was not running at that point. I used '/etc/init.d/vdr start' 
before using xine (which doesn't seem to work), before I used 

	vdr -c /etc/vdr -E /home/cuse/vdr/ -P xine

Am I right, that szap and vdr cannot be used together at the same time? At 
least I get an "resource busy" error when trying to use szap while vdr is 
running. But on the other hand, when vdr is not running and I use szap, I get 
those mentioned error messages:

> 	reading channels from file '/home/me/.szap/channels.conf'
> 	zapping to 8 'ProSieben':
> 	sat 0, frequency = 12480 MHz V, symbolrate 27500000, vpid = 0x00ff, apid =
> 	0x0100
> 	using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
> 	FE_SET_TONE failed: Connection timed out
> 	FE_DISEQC_SEND_MASTER_CMD failed: Connection timed out
> 	FE_DISEQC_SEND_BURST failed: Connection timed out
> 	FE_SET_TONE failed: Connection timed out
>
> szap doesn't return though and every second I get this message on the
> console:
>
> 	status 01 | signal ffff | snr ffff | ber 00000000 | unc 00000000 |

So ATM I cannot select a valid TV channel and xine still shows me a "No 
Signal" screen.

Any help very much appreciated!

Best regards
Christian Schoenebeck