Bug#329251: New release cm-0.6.1

[Alessandro Polverini]

Hello,
a new release of chan-capi is out (changelog follows). It seems like it
compiles also for asterisk 1.2.
A package would be great :)

Alex

Changes:
chan_capi-cm-0.6.1
------------------
- fixed setting of redirecting number rdnis instead of cid.
- allow setting a callerid in the dial() command without changing
  the original channel callerid.
- added config 'defaultcid' to set a default caller id which will be
  used if dial option 'd' is specified.
- moved ast_softhangup() out of interface lock
- use correct mutex_init call for interface lock
- when 'o' option is used for overlap dialing, don't send any digits
  with the CONNECT_REQ. This gives better progress together with 'b'.
- create a pseudo channel for each interface for incoming signalling
  without B-channel.
- added channel locks
- fixed capi init order (thanks to Hans Petter Selasky)
- fixed did handling
- set RDNIS if redirecting number was received.
- simplified call to ast_exists_extension()
- when check for valid extension, check the callerid as well
- changed call-waiting and deflect handling in CONNECT_IND
- use 'immediate' config in MSN mode, if pbx shall be started on
  CONNECT_IND and shall not wait until SETUP/SENDING-COMPLETE was received.
  Since info like REDIRECTINGNUMBER will come after CONNECT_IND, this may
  be lost then. But for some drivers/telcos/pbx, this setting is needed.
- fix start of line interconnect in old mode.
- start early-b3 on PROCEEDING too.
- don't send audio data, if in fax receive mode
- disconnect on finished fax immediately
- don't run through gain list, if gain is 1.0.
- use correct A-law idle value.
- removed old example from capi.conf