[sane-devel] HP ScanJet 4p "no sane devices found"

[Bob Soukup]

Thanks for the prompt reply, Peter.

At your suggestion I tried another scsi cable but still get the same result.  
I don't know if the scanner has or needs a terminator, it worked OK without 
one when it was connected to a Macintosh.  The scsi adapter is an Advansys 
510 ISA.  Think I could have a bad scsi card? 

Thanks

Bob


On Monday 17 December 2001 12:37, you wrote:
> Hi Bob,
>
> looks like your SCSI-communication is not ok. The printouts are correct
> in some parts, but contain also some garbage. sane-find-scanner should
> print
>
> found SCSI processor "HP C1130A 3540" at device /dev/scanner
>
> Can you check if you are using the right cable ?
>
> --Peter
>
> Bob Soukup wrote:
> > I have an HP ScanJet 4p (C1130A) here that I can't get sane to recognize.
> >  I keep getting "no sane devices found".
> >
> > cat /proc/scsi/scsi gives:
> > Attached devices:
> > Host : scsi0 Channel: 00 Id: 02 Lun: 00
> >    Vendor: HP         Model: C1  0A         Rev: 35
> >    Type:    Processor           Ansi SCSI revision: ffffffff
> >
> > Doing "sane-find-scanner" yields:
> > found SCSI processor "HPml  us C1li0Aqt  .3  /d 35/h" at device
> > /dev/scanner found SCSI processor "HP/l  al C1rc0Ari  ir  sr 35ST" at
> > device /dev/sg0 found SCSI processor "HPml  us C1li0Aqt  .3  /d 35/h" at
> > device /dev/sga
> >
> > Doing SANE_DEBUG_HP reports that dev/scanner does not seem to be an HP
> > scanner.  Also /dev/sg0 and /dev/sga report as not HP scanner.
> >
> > Anyone have suggestions as to how to get this puppy to work?
> >
> > Thanks
> >
> > Bob
> >
> > _______________________________________________
> > Sane-devel mailing list
> > Sane-devel at www.mostang.com
> > http://www.mostang.com/mailman/listinfo/sane-devel