[sane-devel] Re: New test version of microtek2 backend

[Karsten Festag]

Argh! Looks like I was very unconcentrated while writing my previous mail
:-(

Some major 'bugfixes':

1) the URL of my homepage is http://home.t-online.de/home/karsten.festag
and therefore the readme is
http://home.t-online.de/home/karsten.festag/software/readme
2) for thesting the X12USL you should not only disable the
'no-backtracking' option but also enable the option 'backend-calibration'.
A scanimage command thus may look like:
scanimage --no-backtracking=no --backend-calibration=yes -l0 -t0 -x100
-y20 2>scan.log >sout.pnm

Regards,

Karsten





Karsten Festag wrote:

> Hi folks
> I made a whole lot of changes to the microtek2 backend (see
> http://me/home/karsten.festag/software/readme).
>
> Especially ADF users should test if the frontend gets now
> SANE_STATUS_NO_DOCS rather than an I/O error in case of an empty ADF.
> And X12 users should  give that version a try. Please use the following
> microtek2.conf file:
>
> option dump 2
> option strip-height 14
> # option lightlid-35 on
> option lineart-autoadjust on
> option toggle-lamp on
> option no-backtrack-option on
> option backend-calibration on
> # option colorbalance-adjust on
> scsi * * Scanner
> # or
> # /dev/sgx
> # where sgx is your scanner device
>
> In you frontend please  --disable--  the option 'no-backtracking' ; if
> you use scanimage:
>
> scanimage --no-backtracking=no .......  does the trick.
>
> Regards
>
> Karsten Festag