[sane-devel] make load plustek 4800P

[Jaeger, Gerhard]

Hard to say why it's not loaded! Normally the driver is able to
detect the scanner and the stays loaded. In your case, the device
seems to be not detected...
Please enable the debug messages by recompiling the driver
with:
make clean all DEBUG=y

Then reload and send us the ouput of dmesg...
It might be a problem of the IEEE1248 settings in the kernels parport 
configuration, it's autodetection sometimes confuses the ASICs inside
the older Plustek devices...

Gerhard

On Sunday, 10. February 2002 19:53, m_toal at another.com wrote:
> Can anybody give me any advice on why pt_drv.o will not load
>
> my bios says parr port is on io:0x378/irq:7
> ive set these values in modules.conf, with differtent variations (leaving
> out the irq=7) but nothing seems to work.
>
> Any help is appreciated.
>
> [root at localhost plustek_driver]# make load
> /sbin/modprobe pt_drv || exit 1
> /lib/modules/2.4.17/misc/pt_drv.o: init_module: Success
> Hint: insmod errors can be caused by incorrect module parameters,
> including invalid IO or IRQ parameters
> /lib/modules/2.4.17/misc/pt_drv.o:
> insmod /lib/modules/2.4.17/misc/pt_drv.o failed
> /lib/modules/misc/pt_drv.o: init_module: Success
> Hint: insmod errors can be caused by incorrect module parameters,
> ncluding invalid IO or IRQ parameters
> /lib/modules/misc/pt_drv.o: insmod /lib/modules/misc/pt_drv.o failed
> /lib/modules/misc/pt_drv.o: insmod pt_drv failed
> make: *** [load] Error 1
>
>