[sane-devel] Why sane_read() always returns SANE_STATUS_GOOD?

[Peter Chen]

Hi,

I will probably do more tests this afternoon. Since I am using kylix, it
might be something wrong with kylix configuration.

I copied a lot of codes from scanimage, except I did not write the image to
stdout like scanimage did. I could not make sane_start work properly if I
called fopen() before sane_start(). Again, it might be something wrong with
my kylix configuration.

Thanks,

Peter

----- Original Message -----
From: "Henning Meier-Geinitz" <henning@meier-geinitz.de>
To: "SANE Mailing List" <sane-devel@mostang.com>
Sent: Saturday, April 26, 2003 7:35 AM
Subject: Re: [sane-devel] Why sane_read() always returns SANE_STATUS_GOOD?


> Hi,
>
> On Fri, Apr 25, 2003 at 10:11:11PM +0200, Henning Meier-Geinitz wrote:
> > Does that also happen if you use the tesb backend instead of the
> > fujitsu backend? That's a good test to find out if you are doing
> > something wrong in the frontend or if it's a backend bug.
>
> I was talking about the "test" backend. I should really use a spell
> checker :-)
>
> Anyway, enabling "test" in dll.conf may be useful in this case.
>
> Bye,
>   Henning
> _______________________________________________
> Sane-devel mailing list
> Sane-devel@www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel
>