[sane-devel] Problem in setting up Xsane

[Holger Drefs]

Hello Stephen,

Wednesday, February 26, 2003, 3:42:29 AM, you wrote:
>> Is your SCSI card recognised in Linux (i.e. what's the output of
>> "cat /proc/scsi/scsi")?

SL> $ cat /proc/scsi/scsi
SL> Attached devices:
SL> Host: scsi0 Channel: 00 Id: 00 Lun: 00
SL>    Vendor: SONY     Model: CD-RW  CRX160E   Rev: 1.0e
SL>    Type:   CD-ROM                           ANSI SCSI revision: 02

SL> It looks the SCSI card detected.
Yes but there should be the scanner as well! This is the machine where
the scanner is attached or? Have you got /dev/sg0 .. sg7?

Forget about sane-find-scanner before your scanner isnŽt shown here.


>> I don't know where xsane got the "setup" device. Did you specify any 
>> command line arguments? (You shouldn't).
SL> I am searching around the "setup" device/step for xsane.  I have been
SL> looking around its website either.

There is a net.conf in C:\sane\etc\sane.d or corresponding path in
linux, you should write here the ip-number of the machine where the
scanner is attached.

Best regards,
 Holger Drefs