[sane-devel] no scanners found (leo s3 scsi-scanner)

[Henning Meier-Geinitz]

Hi,

On Wed, Jan 15, 2003 at 09:59:03PM +0100, axel dammers wrote:
> It's right, the name of the scanner is  LEO LEOScan-S3.
> 
> Here are the output of  "SANE_DEBUG_LEO=255 scanimage -L":
> 
> [sanei_debug] Setting debug level of leo to 255.
> [leo] sane_init
> [leo] This is sane-leo version 1.0-9
> [leo] (C) 2002 by Frank Zago
> [leo] attach_scanner: /dev/sg0
> [leo] leo_init: enter
> [leo] leo_init: exit
> [leo] attach_scanner: opening /dev/sg0
> [leo] leo_identify_scanner: enter
> [leo] device is "LEO" "LEOScan-S3" "1.10"
> [leo] leo_identify_scanner: exit, device not supported

Looks like a detection problem. I don't know anything about the leo
backend, but here is part of the source code (backend/leo.c):

static const struct scanners_supported scanners[] = {
  {6, "ACROSS  ", "                ",
   "Across", "FS-1130"},
  {6, "LEO     ", "LEOScan-S3      ",
   "Leo", "S3"}
};

So the backend expects spaces after the names but the SCSI inqiry
seems to put a 0 after the names (?).

You can verify that by running sane-find-scanner -v -v and looking at
the SCSI inqiry. If there is a 0 after the names, that's the problem.

You can try to modify the source code by removing the spaces after LEO
and LEOScan-S3 to find out,i ft this is the problem.

> In the dll.conf I only uncomment the line with "leo".

Ok.

Bye,
  Henning