[sane-devel] Re: Microtek ScanMaker 8700

Karsten Festag karsten.festag at gmx.de
Thu Feb 19 20:44:47 GMT 2004


Hi John,

[I'm forwarding this mail to the SANE-devel mailing list, maybe we get some 
comments from there]

well, hope never dies...
But to be honest, I personally don't have the possibility to do this. Someone 
who owns this device and has the motivation to do some programming and 
testing may do this, of course. There is a chance that IEE1394 via SBP can 
use the microtek2 backend ("The SBP-2 driver will install
a virtual SCSI controller, and from there on the device can be
accesses by any application that supports SCSI devices. To get
a IEEE-1394 scanner working, you load three modules: ieee1394, ohci1394
(or whatever driver your system requires for your controller) and
sbp2", quotation of Karl-Heinz Kremer)

Is there someone out there who might test if the backend responds to a 
Microtek IEE1394 Scanner??

Best regards

Karsten

On Monday 16 February 2004 17:33, you wrote:
> Hi
>
> Is there any hope of a backend for my Microtek ScanMaker 8700, which is
> connected via IEEE1394? I'm not a programmer, just a magazine editor trying
> to keep working!
>
> Thanks
> John





More information about the sane-devel mailing list