[sane-devel] sane-find-scanner finds Lide20, plustek backend does not

[gerard klaver]

On Thu, 2004-09-23 at 16:42, Lloyd Sumpter wrote:
> Hi,
> 
> My Canon Lide20 (USB) was working on Mandrake 9.0 (sane 1.0.11, iirc and 
> Linux 2.4.x) using scanner.o. I upgraded to Mandrake 10.0 (sane 1.0.13, 
> Linux 2.6.3) and I found scanner.o has been discontinued, and I have to 
> use libusb. Sane tells me the scanner is supported with plustek backend.
> 
> Now, the scanner shows up on usbview and in sane-find-scanner:
> found USB scanner (vendor=0x04a9 [Canon], product=0x220d [CanoScan], 
> chip=LM9832/3) at libusb:001:002
> 
> It's also in /proc/bus/usb/devices as:
> T:  Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#=  2 Spd=12  MxCh= 0
> D:  Ver= 1.10 Cls=ff(vend.) Sub=00 Prot=ff MxPS= 8 #Cfgs=  1
> P:  Vendor=04a9 ProdID=220d Rev= 1.00
> S:  Manufacturer=Canon
> S:  Product=CanoScan
> C:* #Ifs= 1 Cfg#= 1 Atr=a0 MxPwr=500mA
> I:  If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=ff Driver=(none)
> E:  Ad=81(I) Atr=03(Int.) MxPS=   1 Ivl=16ms
> E:  Ad=82(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms
> E:  Ad=03(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms
> 
> (I'm a bit concerned about the "Driver=(none)" - can I change that?)
> 
>     I took the vender and product IDs from sane-find-scanner and made
> plustek.conf as:
> 
> [usb] 0x04a9 0x220d
> device auto
> 
> /etc/fstab has the line:
> none /proc/bus/usb usbfs defaults,devmode=0666  0  0
> 
> (BTW: I'm the only user, so I don't care that ALL users have permission...)
> 
> however, when I set the debug on and run scanimage -L, I get:
> [plustek] usbDev_open(auto,0x04A9-0x220D)
> [plustek] No matching device found!
> [plustek] open failed: -1
> 
> I've also tried making a /dev/usbscanner with mknod and using that, but 
>   that doesn't work either.
> 
> Any help would be greatly appreciated!
> 
> Lloyd Sumpter

Check on www.sane-project.org the README.linux file

check libusb package, hotplug package,
ls -l /proc/bus/usb/001/002 should be at least
 rw-rw----

-- 
----------
m.vr.gr.
Gerard Klaver