[sane-devel] Epson 2480 Transparency Unit - not for me 8-(

[Reinald Kirchner]

Hi everybody,
I replaced the firmware 1.14 with the 1.16 I received (thanks Simon and Ken), 
but I have no change in the behaviour of my scanner. When I address the 
transparency unit, it runs into a loop. The debug ends repeating the attached 
block below over and over.

Any Ideas, any advice?

thanks,
Reinald

[snapscan] atomic_usb_cmd(0,0x81dd3b8,66,0x0,0x0 (0))
[snapscan] usb_cmd(0,0x81dd3b8,66,0x0,0x0 (0))
[snapscan] usb_cmd: cmdlen=10, datalen=56
[snapscan] usb_write: writing:  0x24 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x38 
0x00
[snapscan] Written 10 bytes
[snapscan] usb_read: reading:  0xf8 0x00 0x00 0x00 0x00 0x00 0x00 0x00
[snapscan] Read 8 bytes
[snapscan] usb_write: writing:  0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x30 0x00 
0x00 ...
[snapscan] Written 56 bytes
[snapscan] usb_read: reading:  0xfb 0x02 0x00 0x00 0x00 0x00 0x00 0x00
[snapscan] Read 8 bytes
[snapscan] usb_request_sense
[snapscan] usb_cmd(0,0xbfffcb00,6,0xbfffcae0,0xbfffcad4 (20))
[snapscan] usb_cmd: cmdlen=6, datalen=0
[snapscan] usb_write: writing:  0x03 0x00 0x00 0x00 0x14 0x00
[snapscan] Written 6 bytes
[snapscan] usb_read: reading:  0xf9 0x00 0x00 0x00 0x00 0x00 0x00 0x00
[snapscan] Read 8 bytes
[snapscan] usb_read: reading:  0xf0 0x00 0x02 0x00 0x00 0x00 0x00 0x0b 0x00 
0x00 ...
[snapscan] Read 20 bytes
[snapscan] usb_read: reading:  0xfb 0x00 0x00 0x00 0x00 0x00 0x00 0x00
[snapscan] Read 8 bytes
[snapscan] sense_handler(0, 0xbfffcae0, 0x8163f68)
[snapscan] sense_handler: sense key: 0x02, asc: 0x04, ascq: 0x01, i1: 0x04, 
i2: 0x00
[snapscan] sense_handler: Not ready.
[snapscan] sense_handler: Logical unit is in process of becoming ready. (4 
seconds)
[snapscan] sense_handler: Not ready.


Am Dienstag, 16. August 2005 05:42 schrieb Ken Ramey:
> Great news!!  Using Simon's firmware file results in a good scan with
> the transparency unit without colored bands!
>
> Thank you, Simon!!
>
> ken