[sane-devel] Pb with Xsane

[francois baert]

Le Mercredi 16 Novembre 2005 09:08, vous avez écrit :
> Hello,
> O.S. Fedoracore 4 kernel 2.6.11
> Up to now I have not managed to run xsane.
> here are the results of
> sane-find-scanner:
>   # No SCSI scanners found. If you expected something different, make sure
> that
>   # you have loaded a SCSI driver for your SCSI adapter.
>   # Also you need support for SCSI Generic (sg) in your operating system.
>   # If using Linux, try "modprobe sg".
>
> found USB scanner (vendor=0x04b8 [EPSON], product=0x0101 [Scanner GT-7000])
> at libusb:002:003
>   # Your USB scanner was (probably) detected. It may or may not be
> supported by
>   # SANE. Try scanimage -L and read the backend's manpage.
>
>   # Not checking for parallel port scanners.
>
>   # Most Scanners connected to the parallel port or other proprietary ports
>   # can't be detected by this program.
>
> scanimage -L
> device `epson:libusb:002:003' is a Epson GT-7000 flatbed scanner
> Those information are O.K.  however I observe that in the file
> /proc/bus/usb/devices the driver=none ???
> When i submit xsane the program runs normally at the beginning but
> it hangs when I want to scan a document and after a while I got this
> message: Failure to start the scanner Error I/O on the peripherical.
> I have modified the epson.conf according to the Howto and Faq but I confess
> that I have not found the good answer to solve my problem.
>
> I would appreciate if somebody could give me a piece of advice.
> My Thanks
>
> François Baert