[sane-devel] Configuring a Mustek BearPaw 2400 Scanner

[Richard Ibbotson]

Hi
 
> I hope so. Please try the latest backend gt68xx (1.0-73) from
> http://www.meier-geinitz.de/sane/gt68xx-backend/ or a snapshot of
> http://www.sane-project.org/snapshots/


Right, I've got hold of...

http://www.meier-geinitz.de/sane/gt68xx-backend/gt68xx-backend-only-1.0-74.tar.gz

Opened this up and I can see lots of code such as..

gt68xx.c
gt68xx.conf
gt68xx_devices.c
gt68xx_high.c

But, I'm not sure what to do with this.  I know that the web page says
run ./configure:make:make install but I've tried that and it doesn't
work. Used ./configure and others on many other bits of software but
not able to with the backend software.  Yes, automake and other
software is installed on my Debian Sarge workstation :)

I'm aware that I shouldn't have to send this kind of request to this
list but here it is anyway.

Regards


-- 
Richard