Re: Về Việc: Re: [sane-devel] Firmware for Epson Stylus CX-1500?

Oliver Schwartz Oliver.Schwartz at
Wed May 2 10:16:44 UTC 2007


> All other resolutions give the same result: only green. Even when  
> scanning in Gray mode, blue and red components are missed.
> Do following lines from debug log have any means to this situation?
> [snapscan] snapscani_check_device: Is vendor "EPSON" model "EPSON  
> MFP00" a supported scanner?
> [snapscan] snapscani_get_model_id(EPSON MFP00, 0, 2)
> [snapscan] snapscani_get_model_id: looking up scanner for ID  
> 0x04b8,0x080c.
> [snapscan] snapscani_check_device: Autodetected driver: Unknown
> The model name is not recognized!

> This is my SANE version
> [lhboi at desktop tmp]$ scanimage --version
> scanimage (sane-backends) 1.0.17; backend version 1.0.17

Yes, your version of SANE is too old. Support for the CX-1500 was  
added in sane-backends 1.0.18, so you should upgrade your SANE  
packages. Make sure to uninstall your old version of SANE before you  
install a new one.



More information about the sane-devel mailing list