[sane-devel] Canon LIDE 90

[Pierre Willenbrock]

Ralf Haueisen schrieb:
>> Ralf Haueisen schrieb:
>>> Hi all.
>>>
>>> I am just working to get my Canon LiDE 90 working. I took in the 
>>> genesys_devices.c the LiDE60 an did some changes. I have a sniffer
>>> log taken with usbsnoop. Some registers i could firgue out where to
>>> set them. The image still looks like data is somehow scrambled. There
>>> are some setting in the file for the DAC. (static
>>> Genesys_Frontend Wolfson[] ) to which registers do these data belong?
>>>
>>> TIA,
>>> Ralf
>> The settings in the Genesys_Frontend structs go to the analog frontend
>> via the serial interface at registers 0x3a/0x3b(FEWRDATA)+0x51(FEWRA),
>> through sanei_genesys_fe_write_data.
>>
>> If you are receiving noise data, this may indicate that the byte order
>> was swapped. You should check that the parallel interface to the
>> frontend is setup correctly(registers 0x52 to 0x57).
>>
>> HTH,
>>   Pierre
>>
> 
> I can see a strcture in scan direction but if in directon of the senor
> anything is semared out and noisy, just like i get an average value.
> 

Can you send a small image?