[sane-devel] Canon LiDE 90

[Guillaume Gastebois]

Hello again,

By writing 0x6c=0x12 I have no more power-up problem and pressing 
buttons have no more effect on stopping head. Oufff!!!!

I tryed with 0x1a=24 and 0x16=02 : black image.

Remaining problem : nibbles and calibration.

Regards.
Guillaume

Guillaume Gastebois a écrit :
> Hello,
> 
> Today : regression !!!!
> 
> I tryed to remove lide 35 gpio sequence and to write 0x6b=0x6b & 0x03. 
> The result was : the motor try to move the head to home (but head is 
> still home position). When I press a button, the scanner make a scan and 
> ... don't stop at the end. I see that pressing a button makes that the 
> head stops. I don't understand because in windows snoop only 
> GPIO14,13,12 and 11 moves.
> 
> I tryed writing 0x16=02 and 0x1a=24 and I get an "Extremely low 
> Brightness detected...." (I must open the trap to avoid this and get 
> some black image...)
> 
> Regards
> Guillaume
> 
>