[sane-devel] saned -d6 OK saned fails

[Geoff Lane]

Using a network port scanner and a remote graphical scanner I cannot get either to show or 
connect to port 6566.  If I then issue the command saned I again get no acknowledgement 
of port 6566 but if I issue saned -d6 my graphical scanner connects from a remote computer 
and my network port scanner shows port 6566 as available.

Any reason why this may be? I was under the impression that the -d flag was to run saned 
in debug mode rather than assist or enable a connection.

The only reason I am experimenting with command entries is that I do have inetd installed 
and working and have followed the  MAN  saned instructions I cannot get an 
acknowledgement of port 6566

Geoff Lane
Welwyn Hatfield Computer Club
www.whcc.co.uk