[sane-devel] Epson Stylus SX410 is not recognized although it is listed as supported

[m. allan noah]

That seems more complete, but now we have to wait for someone with
more experience with epson protocol....

allan

On Fri, May 14, 2010 at 1:35 PM, kltrg <m.kltrg at googlemail.com> wrote:
> I started from scratch again, started xsane via the commandline redirecting the output to that file, hit preview scan, git the error message, closes that notification window and closed xsane. The logfile is attached. I hope it worked that time.
>
> kltrg
>
> Am 14.05.2010 18:52, schrieb m. allan noah:
>> I dont see any problems in this file. Are you sure it was not truncated?
>>
>> allan
>>
>> On Fri, May 14, 2010 at 12:46 PM, kltrg <m.kltrg at googlemail.com> wrote:
>>> I attached the logfile to the mail.
>>>
>>> Thanks for all you efforts! kltrg
>>>
>>> Am 14.05.2010 18:01, schrieb m. allan noah:
>>>> well, that looks good, do the same when trying to scan:
>>>>
>>>> SANE_DEBUG_EPSON2=255 xsane 2>xsane.log
>>>>
>>>> go until it gives you an error, and send the log here (compress it if large)
>>>>
>>>> allan
>>>>
>>>> On Fri, May 14, 2010 at 11:41 AM, kltrg <m.kltrg at googlemail.com> wrote:
>>>>> I get this: http://pastebin.com/uG81XyKn
>>>>>
>>>>> Am 14.05.2010 14:40, schrieb m. allan noah:
>>>>>> Try it with the DEBUG flag I gave before...
>>>>>>
>>>>>> allan
>>>>>>
>>>>>> On Fri, May 14, 2010 at 8:07 AM, kltrg <m.kltrg at googlemail.com> wrote:
>>>>>>> I added the line and now I get:
>>>>>>> :~$ scanimage -L
>>>>>>> device `epson2:libusb:002:008' is a Epson PID 0851 flatbed scanner
>>>>>>>
>>>>>>> This sounds good and xsane and gscan2pdf recognize the scanner but I still can't scan. I always get an error message: 'Failed to start scanner: Operation not supported'.
>>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>
>>>>
>>>>
>>>>
>>>
>>
>>
>>
>



-- 
"The truth is an offense, but not a sin"