[sane-devel] Rising project : Support of Konica-Minolta Magicolor 2480MF

[Reinhold Kainhofer]

Am Freitag, 13. August 2010, um 06:29:56 schrieb Jean-Marc CHALLIER:
>  Just a few words to say that the USB frame grabbing is (I think) finished.
> Giving a rapid overview of the captured data, it seems that all frames
> start with ESC (0x1B) and not 0x03, so the protocol is certainly not the
> same as the 1690MF... too bad.

Does it look like the SCL-derived protocol used by the bizhub devices? In 
particular:
   http://wiki.kainhofer.com/hardware/bizhub_scan

When looking at the captured data shown there, you might have to ignore the 
first 12 bytes of each command, as this header data might be used for LAN 
communication only...

All commands start with ESC (0x1b), then * (0x2a), followed by a letter 
(f,o,s,w,z), optionally a number, followed by a letter, again numbers followed 
by a letter (can be multiple numbers - letter sequences... The end of the 
command is always indicated by the letter being uppercase).

Cheers,
Reinhold

-- 
------------------------------------------------------------------
Reinhold Kainhofer, reinhold at kainhofer.com, http://reinhold.kainhofer.com/
 * Financial & Actuarial Math., Vienna Univ. of Technology, Austria
 * http://www.fam.tuwien.ac.at/, DVR: 0005886
 * LilyPond, Music typesetting, http://www.lilypond.org