[sane-devel] LIDE 60. configure scanning prefs?

[Ben Green]

Hi
I'm trying to configure various actions inside my Lide 60 such as  
analogue gain, tinkering with the calibration and the crop area that  
it scans with.

The backend seems to have been abandoned on the support front  -  
scanning is no problem, worked first time - its just this .conf file  
that i cannot drive? is there a list of commands I can feed into  
the .config file? like lamp on/off, red gain +3 ??? i'm afraid i dont  
speak Genesys?

I have done this with some earlier LIDEs that worked with the plustec  
backend - these were quite straightforward - i could open the SANE  
prefs and turn calibration on/off, change gain and crop just by  
changing some zeros and ones.. however this genesys backend has only a  
list of scanners and their model/product addresses - I don't know what  
commands to put into the .conf file.

I'm using SANE: mac10.6:

   TWAIN SANE Interface 2.9 binary  http://www.ellert.se/twain-sane/  
SANE Preference Pane 0.9 binary http://www.ellert.se/twain-sane/ SANE  
backends http://www.sane-project.org/   libusb 0.1.13 beta 2009-09-10  
binary http://libusb.sourceforge.net/


Any Help is Much Appreciated..


Thnaks


Ben
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/sane-devel/attachments/20110209/cafcbcb5/attachment.htm>