[sane-devel] LIDE 60. configure scanning prefs?

[Ben Green]

On 10 Feb 2011, at 05:24, stef wrote:

> Le Wednesday 09 February 2011 18:01:08 Ben Green, vous avez écrit :
>> Hi
>> I'm trying to configure various actions inside my Lide 60 such as
>> analogue gain, tinkering with the calibration and the crop area that
>> it scans with.
>> 
>> The backend seems to have been abandoned on the support front  -
>> scanning is no problem, worked first time - its just this .conf file
>> that i cannot drive? is there a list of commands I can feed into
>> the .config file? like lamp on/off, red gain +3 ??? i'm afraid i dont
>> speak Genesys?
>> 
>> I have done this with some earlier LIDEs that worked with the plustec
>> backend - these were quite straightforward - i could open the SANE
>> prefs and turn calibration on/off, change gain and crop just by
>> changing some zeros and ones.. however this genesys backend has only a
>> list of scanners and their model/product addresses - I don't know what
>> commands to put into the .conf file.
>> 
>> I'm using SANE: mac10.6:
>> 
>>   TWAIN SANE Interface 2.9 binary  http://www.ellert.se/twain-sane/
>> SANE Preference Pane 0.9 binary http://www.ellert.se/twain-sane/ SANE
>> backends http://www.sane-project.org/   libusb 0.1.13 beta 2009-09-10
>> binary http://libusb.sourceforge.net/
>> 
>> 
>> Any Help is Much Appreciated..
>> 
>> 
>> Thnaks
>> 
>> 
>> Ben
> 
> 	Hello,
> 
> 	all user settable settings are published by the backend through options. 
> You can get the full list of active options for your model with 'scanimage -d 
> genesys --help'. There is no options or settings to modify in the conf file.
> 
> Regards,
> 	Stef
> 
> --
> sane-devel mailing list: sane-devel at lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/sane-devel
> Unsubscribe: Send mail with subject "unsubscribe your_password"
>             to sane-devel-request at lists.alioth.debian.org


Hi Steph,

Could you tell me how and where I use this command? (scanimage -d genesys --help)
Is it in the SANE prefs file? if so, do i enter the command under my particular scanner model?
I tried putting this command into terminal but got nothing back -

Sorry I cant profess to know much about command line interface..


Thanks for you help..


Ben