[sane-devel] HP-scanjet 8250 (avision-backend) ADF-not supported
valentine.christian at gmail.com
Thu Nov 17 05:53:43 UTC 2011
I just wanted to say THANK YOU!!! I upgraded my scanning system from
Slack 12.1 to 13.37, and the 1.0.22 sane is distributed with 13.37. It
fired up right away, and BOY IS IT NICE TO HAVE DUPLEX working!!!
I did get a crash with transparency collection. I will play with it more.
This work may be in your distant past, but it is greatly appreciated.
On Sun, Nov 28, 2010 at 7:31 PM, Mike Kelly <mike at piratehaven.org> wrote:
> Thanks to the support of a few testers, especially S. Lipinski, I have
> been able to isolate the command sequence which gets the ADF working.
> Basically, the driver needs to send a reset command to the scanner,
> potentially solving both the initial ADF not working issue and the ADF
> failure after scanning a few pages. Although I now know the right sequence
> to send, I still have to work through a rather annoying trial and error
> process of testing. This process is being tracked in the Alioth bug system.
> If you are able to download, patch, compile, and install sane-backends,
> please try out patch #5 from the bug, and post the results of the debug log
> to the bug system.
> This link should take you to the correct bug entry:
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the sane-devel