[sane-devel] Canon PIXMA MG6350

[Rolf Bensch]

Hi Theo,

Maybe you need to disconnect your device from ethernet before you can
scan at usb.

Cheers,
Rolf


Am 17.03.2013 11:02, schrieb Theo:
> Hi Rolf,
> 
> I did a fresh install from GIT again and the scanning does work. I did
> find an issue: scanning over ethernet (bjnp://) works fine but over USB
> doesn't. This is the debug output when I select the USB connection:
> 
> $ xsane
> [sanei_debug] Setting debug level of pixma to 3.
> [pixma] pixma is compiled without pthread support.
> [pixma] pixma version 0.17.2
> [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007
> [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches
> MG6300 series
> [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at
> bjnp://canon-printer.x.x:8612
> [pixma] pixma_find_scanners() found 2 devices
> [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at libusb:001:007
> [pixma] Scanner model found: Name MG6300(Canon PIXMA MG6300) matches
> MG6300 series
> [pixma] pixma_collect_devices() found Canon PIXMA MG6300 at
> bjnp://canon-printer.x.x:8612
> [pixma] pixma_open(): Canon PIXMA MG6300
> [pixma] Sending time: '13/03/17 10:45'
> [pixma] No response yet. Timed out in 8 sec.
> [pixma] No response yet. Timed out in 7 sec.
> [pixma] No response yet. Timed out in 6 sec.
> [pixma] No response yet. Timed out in 5 sec.
> [pixma] No response yet. Timed out in 4 sec.
> [pixma] No response yet. Timed out in 3 sec.
> [pixma] No response yet. Timed out in 2 sec.
> [pixma] No response yet. Timed out in 1 sec.
> [pixma] WARNING: Error in response phase. cmd:eb80
> [pixma]   If the scanner hangs, reset it and/or unplug the USB cable.
> 
> 
> I'll be doing some more debugging on this later today.
> 
> BTW: printing over USB works fine; itś apparently not the USB stack that
> gives issues.
>