[sane-devel] genesys md6228: buttons supported?

[Stef]

On 27/03/2013 23:12, Dominik Kopp wrote:
> Hi,
>
> does my scanner MD6228 (ID 0461:0377) support the hardware buttons?
> (probably equal to Medion MD 5345)
>
> Because the buttons (OCR, email, copy...) in skanlite as well as in xscan
> are grey.
>
> And scanimage -A shows:
>
> All options specific to device `genesys:libusb:004:003':
>    Scan Mode:
>      --mode Color|Gray|Lineart [Gray]
>          Selects the scan mode (e.g., lineart, monochrome, or color).
>
> ...
>
>          than the vertical resolution this disables horizontal interpolation.
>      --color-filter Red|Green|Blue [Green]
>          When using gray or lineart this option selects the used color.
>    Sensors:
>      --scan[=(yes|no)] [no] [hardware]
>          Scan button
>      --email[=(yes|no)] [no] [hardware]
>          Email button
>      --copy[=(yes|no)] [no] [hardware]
>          Copy button
>      --ocr[=(yes|no)] [no] [hardware]
>          OCR button
>      --power[=(yes|no)] [no] [hardware]
>          Power button
>    Buttons:
>      --clear-calibration
>          Clear calibration cache
>
> --------
>
> Dominik
>
>
     Hello,

     yes they are fully supported. Xsane render them in grey because 
they are read only options. You can test them by:
- pressing a button
- check any other option in Xsane 'advanced options' panel
Then you'll see the checkbox corresponding to the pressed button checked.

Regards,
     Stef