[sane-devel] more patches for epjitsu

[m. allan noah]

I have just committed the bare minimum to sane-backends git repo to
make the S1300i work. I have another round of patches here which do
some cleanups, but they will have to wait a few days.

allan

On Sun, May 25, 2014 at 7:19 PM, m. allan noah <kitno455 at gmail.com> wrote:
> I have all modes and resolutions working now. It will be a couple more
> days before I push to sane-backends.
>
> allan
>
> On Sun, May 25, 2014 at 2:58 PM, Peter D'Hoye <peter.dhoye at gmail.com> wrote:
>>> b) scan with 600dpi
>>> c) scan only front or back (i.e. no duplex)
>>>
>>> Another unsolved issue (at least for me) is that after each invocation of
>>> scanimage, scanadf, ... I need to reset the scanner.
>>> Without it it just reports the infamous "Error during device I/O".
>>> I do not have an idea why?
>>> Ideas welcome.
>>
>> OK, setting 600dpi started a very slow scan with many breaks in
>> between, and resulted in the output of a 64x6900 pixel bitmap. That
>> was with all the scanimage defaults kept, just 600dpi resolution set.
>>
>> the 64 pixel wide strip comes from the exact center of the page.
>>
>> But this is the first time I've seen this scanner do anything under
>> linux so I'm impressed :)
>>
>> Peter
>>
>> --
>> sane-devel mailing list: sane-devel at lists.alioth.debian.org
>> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
>> Unsubscribe: Send mail with subject "unsubscribe your_password"
>>              to sane-devel-request at lists.alioth.debian.org
>
>
>
> --
> "The truth is an offense, but not a sin"



-- 
"The truth is an offense, but not a sin"