[sane-devel] Can sensors be set to a value?

[m. allan noah]

Diogo- what version of sane-backends are you running?

allan

On Fri, Oct 31, 2014 at 11:56 AM, Diogo Pinheiro <dfcpinheiro at gmail.com> wrote:
> Simon Matter <simon.matter <at> invoca.ch> writes:
>
>>
>> Hi,
>>
>> I'm using sane-backends-1.0.24 to access a new Fujitsu fi-7160.
>>
>> The manpage shows this in the Sensor section:
>>
>>     --function <int> [0] [hardware]
>>         Function character on screen
>>
>> My question is, is there a way to set a sensor value by software, not
>> using the buttons on the device?
>>
>> The main question is because Fujitsu has changed the default function to 0
>> in the newest device series while it was 1 in older devices like the
>> fi-6130.
>>
>> Regards,
>> Simon
>>
>
>
> Hi,
>
> Can you complete a scan succefully? I'm trying to scan one document with my
> Fujitsu fi-7160 and it always give me problems due to I/O and EOF.
>
> Thank you.
>
>
> --
> sane-devel mailing list: sane-devel at lists.alioth.debian.org
> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
> Unsubscribe: Send mail with subject "unsubscribe your_password"
>              to sane-devel-request at lists.alioth.debian.org



-- 
"well, I stand up next to a mountain- and I chop it down with the edge
of my hand"