[sane-devel] "Error during device I/O" with Fujitsu fi65-F (epjitsu backend)

[m. allan noah]

Hmm- perhaps you can try scanimage again, but at resolution 300? Also
increase the epjitsu debug level to 25, and don't set the dll debug
level, it is not helpful.

I see a couple possible differences that have never been important
with prior scanners, but perhaps are important with yours.

allan

On Sun, Mar 15, 2015 at 6:53 PM, Jonas Neubert <jonas.neubert at gmail.com> wrote:
> I think this should cover it, started capture before plugging in, then initialization and then a full page scan:
> https://www.dropbox.com/s/y0mz0by18r1uti5/fi65_3.pcap?dl=0
>
> -Jonas
>
> ---- On Sun, 15 Mar 2015 15:39:16 -0700 m. allan noah<kitno455 at gmail.com> wrote ----
>  > Wireshark is fine, but this log does not contain the calibration step,
>  > which is where sane seems to fail. Can you unplug and replug the
>  > device while wireshark is running, and get a log of the initialization
>  > process? I'm not sure if wireshark can do that.
>  >
>  > allan
>  >
>



-- 
"well, I stand up next to a mountain- and I chop it down with the edge
of my hand"