[Babel-users] client to client communication using babel protocol

[Dave Taht]

On Thu, Feb 19, 2015 at 6:58 PM, pramod Jayram <pramod.j94 at gmail.com> wrote:
> Hello everyone,
>   Even i have the same problem. I have created two wireless network one in
> ap mode and other in  adhoc mode with two different ip address which assigns
> ip to clients using dhcp. But a client (not running babel) connected to ap
> cannot find the route generated by the mesh node(router running babel on
> wireles interface) running babeld i.e it cannot ping any other nodes
> available in the network. Is there something that i should be aware of?

ip route

and traceroute are you friends here.

Taking a guess, it is likely you need to be exporting the entire /24
from the network you wish to have people connect to.

by default, babel only exports p2p interfaces, e.g. /32 routes.

put into the the mesh node´s babeld.conf the x.y.z.q. ip address ranges it uses.

redistribute local ip x.y.z.q/24 ge 24 allow

> Thanks
> regards
>
> On Sun, Feb 15, 2015 at 6:30 PM, Juliusz Chroboczek
> <jch at pps.univ-paris-diderot.fr> wrote:
>>
>> > I am in no way an expert with babeld, but I will try to answer your
>> > question.
>>
>> Everything you say is correct.
>>
>> -- Juliusz
>>
>> _______________________________________________
>> Babel-users mailing list
>> Babel-users at lists.alioth.debian.org
>> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/babel-users
>
>
>
> _______________________________________________
> Babel-users mailing list
> Babel-users at lists.alioth.debian.org
> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/babel-users



-- 
Dave Täht

thttp://www.bufferbloat.net/projects/bloat/wiki/Upcoming_Talks