[Nut-upsdev] [HCL] Cyber Power Systems AVRG750U supported by usbhid-ups

Landreville, Xavier xavier.l at magnax.ca
Wed Sep 26 05:39:07 BST 2018

Cyber Power Systems AVRG750U

upsc output:
battery.charge: 100
battery.charge.low: 10
battery.charge.warning: 20
battery.mfr.date: CPS
battery.runtime: 15360
battery.runtime.low: 300
battery.type: PbAcid
battery.voltage: 24.0
battery.voltage.nominal: 24
device.mfr: CPS
device.model: AVRG750U
device.serial: <REDACTED>
device.type: ups
driver.name: usbhid-ups
driver.parameter.offdelay: 60
driver.parameter.ondelay: 120
driver.parameter.pollfreq: 30
driver.parameter.pollinterval: 15
driver.parameter.port: auto
driver.parameter.productid: 0501
driver.parameter.synchronous: no
driver.parameter.vendorid: 0764
driver.version: 2.7.4
driver.version.data: CyberPower HID 0.4
driver.version.internal: 0.41
input.voltage: 121.0
input.voltage.nominal: 120
output.voltage: 129.0
ups.beeper.status: enabled
ups.delay.shutdown: 60
ups.delay.start: 120
ups.load: 2
ups.mfr: CPS
ups.model: AVRG750U
ups.productid: 0501
ups.realpower.nominal: 450
ups.serial: <REDACTED>
ups.status: OL
ups.test.result: Done and passed
ups.timer.shutdown: -60
ups.timer.start: -60
ups.vendorid: 0764

upsrw output:
Remaining battery level when UPS switches to LB (percent)
Maximum length: 10
Value: 10

Remaining battery runtime when UPS switches to LB (seconds)
Maximum length: 10
Value: 300

Interval to wait after shutdown with delay command (seconds)
Maximum length: 10
Value: 120

Interval to wait before (re)starting the load (seconds)
Maximum length: 10
Value: 180

upscmd output:
beeper.disable - Disable the UPS beeper
beeper.enable - Enable the UPS beeper
beeper.mute - Temporarily mute the UPS beeper
beeper.off - Obsolete (use beeper.disable or beeper.mute)
beeper.on - Obsolete (use beeper.enable)
load.off - Turn off the load immediately
load.off.delay - Turn off the load with a delay (seconds)
load.on - Turn on the load immediately
load.on.delay - Turn on the load with a delay (seconds)
shutdown.return - Turn off the load and return when power is back
shutdown.stayoff - Turn off the load and remain off
shutdown.stop - Stop a shutdown in progress
test.battery.start.deep - Start a deep battery test
test.battery.start.quick - Start a quick battery test
test.battery.stop - Stop the battery test

I have tested the shutdown sequence, and this device is affected by the
Cyber Power Systems ondelay/offdelay bug, but otherwise, the sequence works
to turn the power off, then back on when it detects line power.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://alioth-lists.debian.net/pipermail/nut-upsdev/attachments/20180926/82a54d29/attachment.html>

More information about the Nut-upsdev mailing list