[Nut-upsuser] belkin Q:

[Big Wave Dave]

On 12/8/05, Eric S. Johansson <esj at harvee.org> wrote:
> I'm trying to set up a belkin f6c1100-unv UPS to work with nuts.  From
> reading the mailing list, it sounds like the belkinunv serial driver
> should work and that the USB driver is potentially troublesome.  Is this
> a correct impression?
I believe that is correct... unless you run the CVS version of the
code.  I believe there have been recent additions that have cleaned up
these problems.  I have an F6C1100-UNV working over serial right now.

> Also I may have missed this but if I do go with the serial (or USB port)
> is there any simple command line method for verifying basic
> connectivity?  The only reason I ask is I have gone around the drain to
> many times trying to figure out apparent system configuration problems
> when it was really a device configuration problem (i.e. serial cable
> plugged into the wrong port on the back of the PC.  :-)

Check: http://www.networkupstools.org/doc/2.0.1/INSTALL.html
Section 8, 11, and 12 should be helpful for that kinda stuff.

> many thanks
>
> ---eric
>
> _______________________________________________
> Nut-upsuser mailing list
> Nut-upsuser at lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
>


--

----------------------------------------------------------
Are Your Friends Lemmings?
-- http://www.lemmingshirts.com