[Nut-upsuser] APC Smart-UPS v/s 650 variables.

[Dio Brando]

Ok, too many old, I think... :(.

Firmware: [62.J.I]

Regards,
Dio.

Dio Brando ha scritto:
> I'm using a custom cable based on 940-0024C scheme. The acpsmart driver
> in debug mode get me this infos:
> 
> # /sbin/apcsmart -DDD /dev/ttyS1
> Network UPS Tools (version 2.0.3) - APC Smart protocol driver
>         Driver version 1.99.7, command table version 2.0
> debug level is '3'
> Attempting firmware lookup
> Firmware: [62.J.I]
> Not found in table - trying normal method
> APC - Attempting to find command set
> APC - Parsing out command set
> protocol_verify: 0x33 [3] unrecognized
> APC - UPS capabilities determined
> Detected (null) [(null)] on /dev/ttyS1
> update_info_all: starting
> update_info_all: done
> dstate_init: sock /var/run/nut/apcsmart-ttyS1 open on fd 5
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> update_info_normal: starting
> update_info_normal: done
> Signal 2: exiting
> 
> Thanks.
> 
> Arjen de Korte ha scritto:
> 
>>
>>Two things you might check:
>>
>>1) What cable are you using?
>>2) What does the driver mention upon startup?
>>
>>Note that the info you currently get from upsc, may be all that you will
>>ever see. Older APC models will not support more than that. I can't tell
>>from the information you provided so far if your UPS is among these
>>models.
>>
>>Regards,
>>Arjen
>>
> 
> 
> _______________________________________________
> Nut-upsuser mailing list
> Nut-upsuser at lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
>