[Nut-upsuser] Calibrating the Battery on an MGE Ellipse Premium 1200

[Pedro Côrte-Real]

My new MGE Ellipse Premium 1200 is now working fine. I've tested
pulling the plug and the computer shuts down properly and comes back
up when I replug. The only strange behaviour is that when I put the
power back on the battery shows as being at 86%. If it was at 86% it
should have lasted longer. Is there any calibration step I can do? The
only commands the ups seems to support are:

$ upscmd -l mge1200 at localhost
Instant commands supported on UPS [mge1200 at localhost]:

load.off - Turn off the load immediately
load.on - Turn on the load immediately

Pedro.