[Nut-upsuser] Tripp-Lite OmniVS1500XL

[Charles Lepple]

On 10/13/06, John Hobbs <jhobbs at chryxus.ca> wrote:
> 1) In its current state is this providing any shutdown protection at all?

It depends on how the value of ups.debug.S changes when the battery goes low.

Supposedly, the OmniVS1500XL uses the same protocol as the OmniVS1000,
but I am not sure how much of this has been tested. (Note that this is
an "empirical" driver, written by observing the USB protocol of an
OmniVS1000.)

> 2) Assuming it is, is there any way I can turn off the generation of
> these log messages?

Probably not with CentOS. If you can compile from source, and test a
few things, we can cut down on the error messages, but you won't get
status on whatever the D and M commands were trying to check.

-- 
- Charles Lepple