[Nut-upsuser] Powerware 5110

[Kjell Claesson]

Hi Steve.
sön 2007-02-04 klockan 03:30 +1100 skrev Steve Simeonidis:
> I have an FC5 system with a powerware 5110 usb ups.
>  
> The system seems to find the UPS
>  
> ------------------------------
> [root at b1 src]# lsusb
> Bus 004 Device 001: ID 0000:0000
> Bus 003 Device 002: ID 0592:0002 Powerware Corp.
> Bus 003 Device 001: ID 0000:0000
> Bus 002 Device 001: ID 0000:0000
> Bus 005 Device 001: ID 0000:0000
> Bus 001 Device 001: ID 0000:0000
> -------------------------------
>  
> [root at b1 src]# cat /proc/bus/usb/devices
> ......
>  
> T:  Bus=03 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#=  2 Spd=1.5 MxCh= 0
> D:  Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs=  1
> P:  Vendor=0592 ProdID=0002 Rev= 0.50
> S:  Manufacturer=Powerware
> S:  Product=Powerware UPS
> C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA
> I:  If#= 0 Alt= 0 #EPs= 1 Cls=ff(vend.) Sub=00 Prot=00 Driver=(none)
> E:  Ad=81(I) Atr=03(Int.) MxPS=   8 Ivl=20ms
>  
> -----------------------------

Yep that looks OK.
>  
> I have set the port to auto but I can not make it work
>  
> What do I need to set the port to?
>  

The ups.conf should look something like this.

[pw5110]
    driver = bcmxcp_usb
    port = auto
    shutdown_delay = 60
    desc = "USB ups"


Now try to start the driver like this.

/sbin/bcmxcp_usb -a pw5110

If it spit out something like this

--------
Network UPS Tools - BCMXCP UPS driver 0.11 (2.0.5)

Model = POWERWARE UPS    500VA
Firmware = Cont:00.80 Inve:00.60
Shutdown delay =  60 seconds
--------

Then it is ok. If not then check the you have the right
udev rules installed.

Kjell